Tikka T3x TAC A1 .308 Win Bolt-Action Rifle, 20-inch Heavy Threaded Barrel, Folding Adjustable Aluminum Chassis, 10+1
This Finnish-made Tikka T3x TAC A1 in .308 Win stands out with its 20-inch heavy, free-floated threaded barrel, hard-anodized aluminum chassis, and Picatinny top rails on both the receiver and the handguard that align for a near-continuous mounting surface. It features the proven T3x action with a 70-degree bolt lift, a two-stage user-adjustable trigger, and aligned but separate receiver and handguard rails. Offered in excellent condition and CIP proofed, it includes a factory 10-round steel magazine and useful accessories.
Condition
Overall Condition: Excellent condition, showing only faint signs of any prior use or handling.
Bore Overall Condition: Excellent - Clean, mirror finish, no signs of wear.
Bore Rifling: Excellent Rifling - Sharp lands and grooves.
Specific Condition Notes: There are a few light scuffs and scratches on the chassis limited to the exterior surfaces.
What’s Included
- 1x 10-round factory Tikka steel box magazine
- CVLIFE bipod (installed on fore-end rail)
- Three short Picatinny rail sections
- Buttpad spacers for length-of-pull adjustment
- Two-hole QD sling plate
- Various tools
- Original Tikka factory box
The 20-inch heavy-profile, free-floated barrel with a 1:11 twist and threaded muzzle is purpose-built for consistent performance. The combination of a rigid barrel profile and free-float setup supports repeatable accuracy, while the threaded muzzle allows for compatible devices as needed.
The T3x action uses two locking lugs with a 70-degree bolt lift and a plunger ejector for smooth cycling. A large round bolt knob enhances control, and the rifle is configured for right-hand operation. The factory two-stage trigger is user-adjustable to approximately 2–4 lb, paired with a two-position safety that blocks both the trigger and bolt handle.
The hard-anodized aluminum chassis features a folding rear stock with an adjustable cheekpiece and adjustable length-of-pull, plus a rear toe Picatinny rail for positional support. Baseline length of pull is approximately 13.75 inches and can be fine-tuned with the included spacers.
An aluminum M-LOK handguard with an integral top rail pairs with the receiver’s separate Picatinny scope base; they align but are separate pieces, providing a robust, near-continuous mounting surface. Overall length is approximately 39.8 inches open and 30.6 inches folded, with an approximate weight of 10.8 lb. The rifle is CIP proofed and marked “MADE IN FINLAND.”