Remington Model 700 .30-06 Bolt-Action Rifle with Magpul Hunter 700L Stock & Detachable 5-Round AICS Magazine
This long-action Remington Model 700 pairs the proven .30-06 Springfield chambering with a factory-installed Magpul Hunter 700L stock and detachable AICS-pattern magazine conversion. The result is a classic bolt gun upgraded for modern modularity, offering adjustable ergonomics, reliable magazine feeding, and ready-to-mount optics—all atop the time-tested Model 700 action.
Condition
Overall Condition: Good condition, showing some signs of prior use and handling.
Bore Condition: Good – Clean, well-maintained, minor wear marks.
Bore Rifling: Good Rifling – Intact, well-defined lands and grooves.
Specific Condition Notes: Light handling scratches and small finish blemishes are present on the metal surfaces, with very light exterior rust on the barrel. The stock shows a minor mark where the bolt contacts the inlet—common on Magpul Hunter stocks. Bore is bright and shiny.
What’s Included
- Remington Model 700 .30-06 rifle with Magpul Hunter 700L stock
- Magpul Bolt-Action Magazine Well 700L (installed)
- Magpul PMAG 5 AC “Standard LA” 5-round AICS-pattern magazine
- Dual two-piece Picatinny scope bases (installed)
The Magpul Hunter 700L stock brings an aluminum V-bedding block, free-floated barrel channel, and spacer-adjustable length of pull, giving the shooter tunable fit and stable accuracy potential.
An AICS-pattern detachable magazine system replaces the original bottom metal, providing faster reloads and compatibility with widely available long-action magazines. The included 5-round PMAG protrudes below the magwell and does not sit flush.
The 22-inch sporter/medium barrel retains a plain, non-threaded crown and free-floats inside the stock for consistent harmonics. Dual Picatinny bases come pre-installed, so adding a preferred optic is straightforward.
Core Model 700 features remain intact: a two-lug bolt with a round knob handle, the familiar two-position safety, and a crisp single-stage trigger with a serrated shoe. The matte-gray steel receiver is drilled and tapped from the factory and is proudly made in the United States.