Glock G27 Gen 3 .40 S&W Subcompact Pistol – Austrian 2013 CIP Proof, Triple-Matched Serials, 9+1 Capacity
This Glock G27 Gen 3 is a factory-configured, Austrian-made subcompact chambered in .40 S&W. It carries 2013 CIP 'AT' proof marks, and its slide, frame, and barrel all share matching serial numbers. A 3.43 inch polygonal-rifled barrel, Safe-Action trigger, and compact frame make it a proven concealed-carry choice, while an aftermarket strike plate is pre-tapped for a clip mount to streamline belt carry.
Condition
Overall Condition: Very good condition, showing only light, superficial signs of prior handling or use.
Bore Condition: Excellent – Clean, mirror finish, no signs of wear.
Rifling Condition: Excellent – Sharp lands and grooves.
Specific Notes: The slide shows a few small scuffs from handling, and an aftermarket rear strike plate is installed with screws for optional belt-clip attachment. All mechanical functions check out.
What’s Included
- Glock factory hard plastic case
- Glock instruction manual
- Factory fired casing envelope (serial VNM885)
- Two 9-round OEM magazines
- Extra screws for strike plate/belt clip setup
This G27 delivers Glock's proven striker-fired, short-recoil action in a subcompact package built for .40 S&W pressures. The 5.5 lb Safe-Action trigger and locked-breech design provide the familiar, consistent pull Glock owners expect.
The 3.43 in steel barrel uses Glock's polygonal rifling for a tight gas seal and reduced fouling, contributing to the excellent bore condition noted above. Right-hand twist stabilizes standard .40 S&W bullet weights effectively.
Austrian CIP proof marks and the 'AT' date code place production in 2013, and the serial numbers match across the slide, frame, and barrel—an attractive detail for collectors who value original factory pairing.
The Gen 3 polymer frame features molded finger grooves and no accessory rail, keeping the profile slim for concealment. Fixed polymer sights with a white-dot front and white-outline rear offer a familiar sight picture.
An aftermarket rear strike plate already fitted with threaded holes (and supplied screws) lets the next owner install a belt clip for inside-the-waistband carry without altering the slide. The pistol remains fully compatible with higher-capacity Glock .40 S&W magazines.