Smith & Wesson Model 64-8 K-Frame .38 Special +P Revolver, 4 in Heavy Two-Piece Barrel, Stainless, 6-Shot
This Smith & Wesson Model 64-8 is a full-size K-Frame .38 Special +P revolver built from stainless steel with a satin finish. It features a two-piece heavy 4 inch barrel, fixed sights, and a six-shot fluted cylinder. The CHM serial prefix points to circa 2004 production, and the Model 64 line was discontinued in October 2021. Aftermarket Pachmayr "Gripper" rubber stocks are installed for a secure hold.
Condition
Overall Condition: Good condition, showing some signs of prior use and handling.
Bore Condition: Good - Clean, well-maintained, minor wear marks.
Bore Rifling: Good Rifling - Intact, well-defined lands and grooves.
Specific Condition Notes: This revolver shows visible signs of prior handling and use. The exterior has scattered scratches and small blemishes.
What's Included
- Smith & Wesson Model 64-8 .38 Special +P revolver
- Pachmayr "Gripper" rubber stocks (installed)
The Model 64-8 pairs a classic K-Frame with .38 Special +P capability and a six-shot fluted cylinder, offering a familiar DA/SA layout with an exposed hammer and a smooth-faced trigger. Its full-size format delivers a steady sight picture and comfortable handling.
The barrel is a 4 inch heavy, two-piece stainless design that adds rigidity and balance. Fixed sights consist of a serrated ramp front and a square-notch rear cut into the topstrap for a clean, snag-free profile.
Construction is all stainless steel with a satin finish across the frame, cylinder, and barrel. Factory markings read "MADE IN U.S.A. / MARCAS REGISTRADAS / SMITH & WESSON / SPRINGFIELD, MASS."
Safety features include the internal key lock. The installed Pachmayr "Gripper" rubber stocks provide a secure, hand-filling grasp. The CHM serial prefix indicates production around 2004, and the Model 64 line ended production in October 2021.