Remington 1911 R1 Enhanced 9mm Government, 5 in Match Stainless Barrel, Satin Black Oxide, Adjustable Rear & Red Fiber-Optic Front, 10+1
This Remington 1911 R1 Enhanced in 9mm Luger pairs the classic Government-length format with factory upgrades that matter. It features a match-grade stainless 5 in barrel with a stainless bushing, a carbon-steel frame and slide finished in satin black oxide, and target-focused sights with an adjustable rear and a red fiber-optic front. Huntsville, Alabama markings confirm USA production during the 2014–2020 era, and it comes with two 10-round and one 9-round steel magazines.
Condition
Overall Condition: Very good condition, showing only light, superficial signs of prior handling or use.
Bore Condition: Excellent - Clean, mirror finish, no signs of wear.
Bore Rifling: Excellent Rifling - Sharp lands and grooves.
Specific Condition Notes: There are light indications of handling and wear visible on exterior surfaces.
What’s Included
- Remington factory cardboard box (green)
- Remington 1911 R1 owner's manual
- Two 10-round and one 9-round steel 9mm 1911 magazines (markings include '9mm Luger' with numbered witness slots and '9MM' with round witness holes)
The R1 Enhanced configuration delivers practical 1911 upgrades from the factory. The Government-length slide runs on a carbon-steel frame, both finished in a satin black oxide that complements the gray textured grip panels. A match-grade stainless barrel and stainless bushing are paired with a standard GI recoil system and checkered plug for a traditional, service-ready setup.
Sight picture and slide manipulation are thoughtfully executed. The rear sight is fully adjustable and dovetailed, while the front uses a dovetailed red fiber-optic rod for fast acquisition. Front and rear cocking serrations aid handling, and a lowered and flared ejection port supports reliable cycling.
Controls and ergonomics are tuned for confident operation. The pistol uses a single-action, short-recoil system with a skeletonized rowel hammer and a skeletonized, match anodized aluminum trigger. An extended single-side thumb safety and a beavertail grip safety with a memory bump provide secure engagement. The front strap is checkered, and the mainspring housing is flat and checkered for a consistent grip. The grip panels include a thumb-relief cut at the magazine release.
Chambered in 9mm Luger, the pistol has a 9+1 factory capacity (10+1 with the supplied 10-round magazines) and includes two 10-round and one 9-round steel magazines. Production and marking details reflect Huntsville, Alabama manufacture (2014–2020), and the frame is marked 'REMINGTON ARMS CO., HUNTSVILLE, AL USA.' Remington part number 96364 corresponds to this Enhanced 9mm variant with its factory sighting and match-barrel features.