Ruger American Rifle Ranch 5.56 NATO Bolt-Action, 16.10-inch Threaded Barrel, FDE Stock, 2015, Three Flush-Fit Rotary Magazines
Built in 2015, this Ruger American Rifle Ranch in 5.56mm NATO pairs a compact 16.10-inch threaded, free-floated medium-taper barrel with a 1:8 twist and an installed three-port brake. It features a three-lug bolt with a 70-degree lift, Ruger Power Bedding system, and a Flat Dark Earth synthetic stock. A receiver-mounted one-piece Picatinny scope rail is installed, and this example uses the early flush-fit 4+1 rotary magazine configuration. A sling-stud mounted bipod comes attached. Three flush-fit rotary magazines are included.
Condition
Overall Condition: Very good condition, showing only light, superficial signs of prior handling or use.
Bore Condition: Excellent - Clean, mirror finish, no signs of wear.
Bore Rifling: Excellent Rifling - Sharp lands and grooves.
Specific Condition Notes: There are minimal markings from previous handling and use. The bore is bright and clean. Please refer to the photos for a detailed view.
What's Included
- Sling-stud mounted bipod (attached)
- Three-port muzzle brake (installed)
- One-piece Picatinny scope rail (installed)
- Three flush-fit rotary magazines (Ruger American pattern)
The Ranch model configuration delivers a handy 16.10-inch barrel with a threaded muzzle and a medium-taper profile. The barrel is free-floated in the channel to support consistent accuracy, and the 1:8 twist rate suits a broad range of 5.56mm NATO loads. A three-port, side-ported brake is installed at the muzzle.
The action uses a three-lug bolt with a 70-degree lift for ample scope clearance and fast cycling. Ruger’s Power Bedding system secures the receiver in steel bedding blocks for repeatable alignment. The Marksman Adjustable trigger is factory-equipped.
The Flat Dark Earth synthetic stock features molded texturing and a rubber recoil pad, with a 12.75-inch length of pull. Front and rear sling swivel studs are installed, and a sling-stud mounted bipod is attached. Metalwork wears a matte black finish.
This rifle uses the early flush-fit rotary magazine configuration with a 4+1 capacity. The receiver has a one-piece Picatinny scope base installed. There are no iron sights. It is made in the USA and was manufactured in 2015.