Smith & Wesson Bodyguard 2.0 .380 ACP Micro Pistol, No Thumb Safety, 2.75 in Barrel, 10+1, Armornite - SKU 13927
The Smith & Wesson Bodyguard 2.0 in .380 ACP is a micro-size, striker-fired pistol configured without a thumb safety (SKU 13927). It pairs a stainless steel barrel and slide with an Armornite finish, a bright orange-dot tritium front sight, and a single-column 10+1 capacity in a slim 0.88 in profile. Lightweight at about 9.8 oz unloaded, it is built on a polymer frame with practical controls and features that emphasize dependable operation.
Condition
Overall Condition: Very good condition, showing only light, superficial signs of prior handling or use.
Bore Overall Condition: Good - Clean, well-maintained, minor wear marks.
Bore Rifling: Good Rifling - Intact, well-defined lands and grooves.
Specific Condition Notes: Light signs of wear and handling are present on exterior surfaces consistent with careful prior use.
What's Included
- Smith & Wesson factory cardboard box (matching Bodyguard 2.0 NTS label, SKU 13927)
- Smith & Wesson Safety & Instruction Manual for Bodyguard 2.0 Pistols
- Lock
- 1x 10-round single-stack steel magazine with orange follower (fits Bodyguard 2.0 .380)
This Bodyguard 2.0 is the No Thumb Safety variant, identified by SKU 13927 and the matching box label. It is a striker-fired, locked-breech, recoil-operated design sized for minimal bulk, with approximate overall dimensions of 5.5 in L x 4.0 in H x 0.88 in W and an unloaded weight of about 9.8 oz.
The sighting system combines a fixed U-notch rear with a tritium bright orange-dot front sight marked TG-H3. Deep, scalloped serrations at the front and rear of the stainless slide aid manipulation, and the external extractor is configured for reliable case control. Both the slide and the 2.75 in stainless barrel wear a durable Armornite finish.
Controls are streamlined and practical: a reversible magazine release supports either side, and the flat-faced trigger provides a consistent press. Safety features include a trigger safety tab and an internal striker block, with no external thumb safety. The stippled polymer grip with S&W medallions and an 18-degree grip angle promote a natural point of aim.
This example is marked SMITH & WESSON MARYVILLE, TN U.S.A. and ships with a single-column steel magazine offering 10+1 capacity in .380 ACP. The serial on the factory box matches the pistol, and the configuration aligns with manufacturer part number 13927, made in the United States.