CVA Stag Horn .50 Cal Inline Muzzleloader, 24 in Blued Barrel, Synthetic Stock, Fiber-Optic Sights
This CVA Stag Horn is a .50 caliber inline muzzleloader built with a bolt/plunger single-shot action and a practical feature set for the field. It has a 24-inch blued barrel with a recessed crown and a 1:32 twist, fiber-optic open sights, and a durable black synthetic stock. The top is drilled and tapped with a base block installed, and the barrel is rollmarked "Black Powder Only." Made in Spain, it carries clear factory markings, including the 700 kp/cm2 pressure marking.
Condition
Overall Condition: Good condition, showing some signs of prior use and handling.
Bore Condition: Fair - Generally clean, some residue or smudges, slight corrosion.
Bore Fouling: Moderate Fouling - Powder fouling with noticeable buildup.
Bore Rifling: Fair Rifling - Worn rifling, slight loss of definition.
Specific Condition Notes: The exterior shows moderate handling wear consistent with normal field use. Metal surfaces retain functional finish with minor surface marks and light wear. The synthetic stock has handling impressions and minor cosmetic blemishes but remains structurally sound. All rollmarks and proof marks are clear and legible. The bore exhibits fouling typical of regular black powder use, with rifling visible.
What’s Included
- CVA Stag Horn .50 caliber inline muzzleloader rifle
- Installed scope base (receiver/barrel top drilled and tapped)
- Fiber-optic open sights (orange front ramp, green rear notch)
The Stag Horn’s inline bolt/plunger action provides straightforward operation with a single-shot design and a manual bolt safety. The barrel is marked "Black Powder Only" and features a recessed crown to help protect the muzzle in the field.
The 24-inch blued barrel uses a 1:32 twist rate, a common pairing for modern .50 caliber muzzleloader projectiles. The bright fiber-optic sights include an orange front ramp and a green rear notch for quick sight alignment.
The black synthetic stock is built for practical use, with molded checkering for grip, a straight comb, and a buttpad. Sling swivel studs are installed, including a fore-end stud for carry support.
The receiver/barrel top is drilled and tapped and fitted with a base block. Factory markings are clear, including "Made in Spain" and the 700 kp/cm2 pressure marking. Length of pull measures 14.0 inches.