Remington Model 1100 12 Gauge Barrel Assembly – 30" Vent Rib, Fixed Full Choke, 2-3/4 inch Chamber, 1970
This is a Remington Model 1100 12-gauge barrel assembly manufactured in 1970, finished in blued steel and configured with a ventilated rib and single front bead. It features a fixed Full choke and is chambered for 2-3/4 inch shells. The barrel carries the REP-in-oval proof and a star inspection mark, with factory roll markings indicating Remington manufacture in Ilion, New York.
Listed as a "Remington 1100 12 Ga 30 inch Vent Rib Barrel," this assembly is designed to fit Model 1100 12-gauge receivers.
Condition
Overall Condition: Very good condition, showing only light, superficial signs of prior handling or use.
Bore Condition: Smoothbore; specific bore condition not provided.
Specific Condition Notes: The barrel shows light use, and there is some discoloration in places.
What's Included
- Remington Model 1100 12-gauge barrel assembly (barrel only)
This barrel assembly is built for the gas-operated Remington Model 1100 and fits 12-gauge receivers. It is chamber-marked for 2-3/4 inch shells only, ensuring straightforward compatibility for standard 2-3/4 inch 12-gauge loads.
The ventilated rib features longitudinal serrations with a single front bead and no mid-bead observed. The choke is fixed and marked "FULL." These are factory features as roll-marked and observed on the barrel.
Construction is blued steel with the correct Remington roll mark: "REMINGTON ARMS CO., INC. ILION, N.Y. MADE IN U.S.A." The barrel carries the REP-in-oval proof and a star inspection mark, consistent with Remington factory proofing and inspection practices.
Barrels for the Model 1100 are not serialized and are dated by small barrel codes near the receiver; this example is noted as manufactured in 1970. The chamber is marked "12 GA. FOR 2 3/4 IN. SHELLS" with a preceding star symbol.
The listing identifies this as a Remington 1100 12 Ga 30 inch Vent Rib Barrel.