Colt Anaconda Realtree Camo .44 Mag, 8-inch Stainless DA/SA, 6-Shot, 1997, with Redfield 2.5-7x Pistol Scope
This factory Colt-Realtree camouflaged Anaconda is a notable 1997-production, large-frame .44 Magnum with an 8-inch heavy barrel, ventilated rib, and full-length underlug. It comes equipped with a camo-finished Redfield EER 2.5-7x pistol scope on a screw-attached topstrap base and includes the Team Colt Realtree soft case. The barrel carries the correct COLT REALTREE over .44 MAGNUM rollmark, and the MM-prefix serial confirms its Anaconda series lineage.
Condition
Overall Condition: Good condition, showing some signs of prior use and handling.
Bore Condition: Excellent - Clean, mirror finish, no signs of wear.
Bore Rifling: Excellent Rifling - Sharp lands and grooves.
Specific Condition Notes: The action cycles smoothly and the lockup is tight. Minor scratches and blemishes are present. Pitting is visible inside the frame and on the crane. Finish blemishing is present on the rear of the cylinder.
What's Included
- Redfield EER 2.5-7x pistol scope (camo finish) installed in two rings on a screw-attached topstrap base; crosshair reticle; flip-up lens caps
- Team Colt Realtree soft case
Built on Colt’s large MM-frame, this DA/SA stainless-steel revolver features a six-shot fluted cylinder and an external hammer with a serrated spur. The frame, barrel, and cylinder wear the factory Realtree camouflage finish, with the left side marked by the Colt Pony logo.
The 8-inch heavy barrel combines a ventilated rib with a full-length underlug, pairing weight and sighting stability for magnum loads. The topstrap is drilled and tapped and currently fitted with a screw-attached base that secures the optic.
Optics are handled by a camo-finished Redfield EER 2.5-7x pistol scope with a crosshair reticle and flip-up lens caps, mounted in two rings. With the base and scope installed, the revolver is configured for optic use and iron sights are not utilized in this setup.
Factory rollmarks read COLT REALTREE over .44 MAGNUM on the barrel, reinforcing this variant’s identity. The MM-prefix serial confirms its Anaconda series origin. Grips are black rubber finger-groove with a molded Colt logo, providing a solid hold on this full-size revolver. Made in the USA in 1997.