Sig Sauer P365 SAS-C 9mm Micro-Compact, Ported Barrel & Slide, FT Bullseye Sight, Nitron Finish, 4 Magazines
The P365 SAS-C is the dehorned, Anti-Snag variant of Sig Sauer's proven micro-compact 9mm. This SAS-C features a factory ported barrel and slide, a flush-mounted FT Bullseye fiber-tritium sight integrated into the slide, and a Nitron-finished slide over a black polymer grip module. It ships with four magazines and retains the micro footprint with a 3.1 in barrel and approximately 5.8 in overall length, manufactured in Newington, New Hampshire, USA.
Condition
Overall Condition: Very good condition, showing only light, superficial signs of prior handling or use.
Bore Condition: Excellent - Clean, mirror finish, no signs of wear.
Bore Rifling: Excellent Rifling - Sharp lands and grooves.
Specific Condition Notes: There are only a few faint handling marks visible under close inspection. Photos provide close-up views of the slide, frame, and controls for reference.
What's Included
- SIG Sauer factory hard case with SIG logo (gray)
- Owner's manual
- 2x 12-round steel P365 magazines (Made in USA marked; mix of short and finger-extension baseplates as shown)
- 2x 10-round steel P365 magazines (Made in USA marked; mix of short and finger-extension baseplates as shown)
The SAS (Sig Anti-Snag) configuration gives this P365 a streamlined profile with dehorned edges and low-profile controls. The slide integrates the flush-mounted FT Bullseye fiber-tritium sight, eliminating raised front and rear sights for a smooth draw.
This SAS-C variant includes a factory ported barrel and ported slide. The system pairs with the micro-compact 3.1 in barrel and approximately 5.8 in overall length to keep the package trim and easy to carry.
The slide wears a durable Nitron finish with forward and rear serrations for confident manipulation. The black polymer grip module features micro-texture for purchase and retains a short accessory rail slot on the dustcover.
It is a striker-fired 9mm Luger with a micro form factor and a 12+1 capacity when using the included 12-round magazines. The package includes two 12-round and two 10-round steel magazines, each marked Made in USA and provided with a mix of short and finger-extension baseplates.
Manufactured in Newington, New Hampshire, USA, this P365 SAS-C is identified by Sig Sauer part number 365-9-SAS-C and is built in the micro category with the SAS-specific sighting system and ported slide and barrel.