Savage Model 12 LRP 6.5 Creedmoor Bolt-Action Rifle, 26-Inch Fluted Heavy Barrel, AccuTrigger, HS Precision Composite Stock, With Bipod, Picatinny Base & Seekins 30mm Rings & Case
This Savage Model 12 LRP in 6.5 Creedmoor is set up for precision shooting with a 26-inch fluted, heavy-profile, free-floating barrel and the Savage Target AccuTrigger. It features an HS Precision composite stock with an aluminum bedding block and an added adjustable cheek riser. Installed upgrades include a one-piece Picatinny scope base, Seekins Precision 30mm rings, and a sling-stud mounted bipod. The rifle is in very good overall condition with an excellent bore.
Condition
Overall Condition: Very good condition, showing only light, superficial signs of prior handling or use.
Bore Condition: Excellent - Clean, mirror finish, no signs of wear.
Bore Rifling: Excellent Rifling - Sharp lands and grooves.
Specific Condition Notes: Light handling marks are visible on exterior surfaces. Please refer to the photos for a close look at the noted areas.
What's Included
- Bipod: Sling-stud mounted bipod (installed)
- Scope Rings: Seekins Precision 30mm scope rings (installed)
- Scope Base: One-piece Picatinny scope base (installed)
- Cheek Riser: Bolt-on adjustable cheek riser (installed)
- Case
The Model 12 LRP (Long Range Precision) pairs a bolt-action receiver with a 26-inch, fluted heavy barrel that is free-floated and finished with a recessed target crown. The barrel is non-threaded and secured using Savage's barrel nut system for precise headspace control.
The Savage Target AccuTrigger is user-adjustable and includes the distinctive red blade. Safety provisions include a tang-mounted, three-position safety. Controls are complemented by a right-side bolt release, an oversized round bolt knob, and a spiral-fluted bolt body.
The black textured fiberglass/composite stock is built around an aluminum bedding block for rigidity and consistency. It features a beavertail forend, sling studs, and an HS Precision recoil pad. A bolt-on adjustable cheek riser is installed to fine-tune head position. Length of pull measures 13.5 inches.
Mounting hardware is already in place: a one-piece Picatinny scope base and Seekins Precision 30mm rings are installed. A sling-stud mounted bipod is attached to the forend for added stability at the bench or in the field.
This rifle feeds from a detachable box magazine and is chambered in 6.5 Creedmoor, offering a 4+1 capacity. It is made in the USA.