Colt Anaconda .44 Rem Magnum, Factory-Ported 8-inch Stainless DA/SA Revolver (1998, PDT Configuration)
This Colt Anaconda stands out as a factory-ported, 8-inch PDT configuration from 1998 with stainless-steel construction and classic Colt features. It carries the AN-prefix serial range associated with late-1990s Custom Shop-era Anacondas and the catalog code MM3080PDT that denotes .44 Magnum, 8-inch, stainless, ported specification. It includes the Colt factory case with matching end label and the original double-action revolver manual.
The 8-inch stainless barrel features factory ports at the muzzle, a ventilated top rib, and a full-length underlug. The front sight is a pinned red/orange ramp, paired with a fully adjustable rear sight for a clean, precise sight picture.
This DA/SA revolver is equipped with a wide, serrated target hammer and a knurled ejector-rod tip. The six-shot fluted cylinder and Colt-branded black rubber finger-groove grips with Colt medallions round out the classic Anaconda profile.
Stainless steel is used throughout the frame, barrel, and cylinder, with the Colt rampant pony logo on the frame and left/right barrel rollmarks present. The configuration, markings, and factory porting align with the MM3080PDT code specifics.
Made in the United States in 1998, this Anaconda captures the late-1990s production era with the AN-prefix serial range and the desirable factory-ported PDT setup.
Condition
Overall Condition: Fair condition, showing extensive signs of prior use and handling.
Bore Condition: Good - Clean, well-maintained, minor wear marks.
Bore Rifling: Good Rifling - Intact, well-defined lands and grooves.
Specific Condition Notes: The grips are damaged, and a missing nut prevents them from being secured. Slowly pulling the trigger in double-action can cause the action to jam mid-pull.
What’s Included
- Colt factory blue hard case with matching end label (Model MM3080PDT; AN-prefix serial noted)
- Colt Double Action Revolver instruction/owner's manual