Smith & Wesson Model 66-2 Combat Magnum .357 Magnum, 6-inch Stainless K-Frame Revolver
This Smith & Wesson Model 66-2 is a stainless K-Frame Combat Magnum chambered in .357 Magnum with a 6-inch heavy barrel. It pairs classic DA/SA operation with fully adjustable sights and checkered wood stocks, and reflects the -2 engineering change with a non-recessed cylinder.
The barrel features a full-length serrated rib and a partial ejector-rod shroud, while the top strap is serrated to cut glare. The pinned ramp front sight with red/orange insert and fully adjustable square-notch rear deliver a clean, precise sight picture. Stainless construction with a brushed/satin finish adds durability and an attractive, functional look.
Controls include an exposed hammer with a wide checkered spur, a smooth-faced trigger, and a checkered cylinder latch. The six-shot fluted cylinder, DA/SA action, and square-butt grip frame provide the familiar handling and balance the Model 66 line is known for.
As a 66-2, this example aligns with the factory transition that removed counterbored chambers and pinned barrels; the cylinder is non-recessed. It wears checkered wood stocks with S&W medallions and is marked MOD. 66-2 on the yoke.
Condition
Overall Condition: Good condition, showing some signs of prior use and handling.
Bore Condition: Good - Clean, well-maintained, minor wear marks.
Bore Rifling: Good Rifling - Intact, well-defined lands and grooves.
Specific Condition Notes: The revolver shows scattered cosmetic imperfections, including scratches, small blemishes, and areas of finish loss. It presents as a solid, well-kept example.
What’s Included
- Smith & Wesson Model 66-2 revolver
This Model 66-2 is the stainless Combat Magnum on the K-Frame, chambered in .357 Magnum with a six-shot fluted cylinder. The 6-inch heavy barrel with a full-length serrated rib and partial ejector-rod shroud gives it a purposeful profile and steady sight alignment.
The sighting system is built for clarity: a pinned ramp front sight with a red/orange insert and a fully adjustable square-notch black serrated rear, supported by a serrated top strap to reduce glare.
Operational features include DA/SA action, a smooth-faced trigger, an exposed hammer with a wide checkered spur, and a checkered cylinder latch for positive manipulation. The square-butt grip frame wears checkered wood stocks with S&W medallions.
Constructed of stainless steel with a brushed/satin finish on the frame, barrel, and cylinder, this U.S.-made revolver is marked MOD. 66-2 on the yoke. As a -2 engineering change, it reflects the period update with a non-recessed cylinder.