Ruger New Model Blackhawk .357 Magnum 6.5 in Satin Stainless Single-Action Revolver (2009)
This 2009 Ruger New Model Blackhawk in .357 Magnum pairs a 6.5-inch stainless barrel with a satin stainless finish on the barrel, frame, and cylinder, and adjustable iron sights. The sights are the standard Ruger configuration, with a black/anodized rear assembly and a black front blade pinned to a stainless base. It features the Ruger transfer-bar system for safe carry of six, a six-flute cylinder, and smooth hardwood grips with Ruger medallions. Made in the United States, it is also listed by Ruger as compatible with .38 Special (+P) per the factory manual.
Condition
Overall Condition: Good condition, showing some signs of prior use and handling.
Bore Overall Condition: Good - Clean, well-maintained, minor wear marks.
Bore Rifling: Good Rifling - Intact, well-defined lands and grooves.
Specific Condition Notes: Minor scratches and small blemishes are present on exterior surfaces. The cylinder face shows light carbon scorching. There are a few very small, scattered pitting spots on the frame.
What's Included
- Ruger factory hard plastic case
- Ruger New Model Blackhawk / Super Blackhawk / Hunter & Bisley instruction manual
- Factory fired test casing
The stainless steel barrel, frame, cylinder, and receiver share a uniform satin stainless finish that is easy to read against the sights and complements the smooth hardwood grips with Ruger medallions. The revolver uses a six-flute cylinder and a full-length under-barrel ejector-rod housing with a spring-loaded base-pin latch.
The 6.5-inch barrel has a 1:16 inch twist, and the sighting system consists of a ramped front blade and a fully adjustable rear sight. Protective sight ears on the topstrap help shield the rear sight assembly.
This single-action New Model Blackhawk employs Ruger’s transfer-bar system, allowing safe carry of all six chambers. It is chambered in .357 Magnum with a 6-round capacity and, per the Ruger manual, is compatible with .38 Special, including +P loads.
Manufactured in 2009 in the United States, this example carries Ruger’s standard barrel warning rollmark referencing Ruger, Newport, NH, USA. The factory designation for this configuration is mfg part number 0319.