Browning X-Bolt Hell's Canyon Long Range .300 Win. Mag., 26 in Fluted Threaded Barrel, Matte Bronze, Recoil Hawg Brake
This Browning X-Bolt Hell's Canyon Long Range in .300 Win. Mag. combines a 26 inch fluted, threaded barrel with a matte bronze finish and a factory-installed Browning Recoil Hawg muzzle brake. It features a composite tan/earth camo stock, a fast 1:8 twist rate, and an oversized bolt handle. Built by Miroku in Japan, it comes equipped with a one-piece Picatinny scope rail and a detachable Long Magnum rotary magazine.
Condition
Overall Condition: Very good condition, showing only light, superficial signs of prior handling or use.
Bore Condition: Good - Clean, well-maintained, minor wear marks.
Bore Fouling: Mild Fouling - Light buildup of fouling or dirt.
Bore Rifling: Good Rifling - Intact, well-defined lands and grooves.
Specific Condition Notes: The MTNGEAR short Picatinny forend rail section is installed slightly crooked on the forend.
What’s Included
- 1x Browning X-Bolt Long Magnum detachable rotary magazine (3-round, factory)
- One-piece Picatinny scope rail (installed)
- Browning Recoil Hawg muzzle brake (installed)
- MTNGEAR short Picatinny forend rail section (installed)
The Hell's Canyon Long Range configuration pairs the .300 Win. Mag. chambering with a 26 inch fluted barrel for extended velocity potential and stable heat management. The barrel is threaded and fitted with Browning's Recoil Hawg brake, and the rifle wears a uniform matte bronze finish across the barreled action.
The composite tan/earth camouflage stock provides durable field utility with textured grip areas and a straight comb. It is outfitted with front and rear sling studs and a 13.75 inch length of pull. An oversized bolt handle aids manipulation, and the top-tang safety with bolt unlock button supports administrative handling.
This X-Bolt uses Browning's detachable Long Magnum rotary magazine system, marked accordingly, with a 3+1 capacity. One factory 3-round magazine is included. Receiver markings note Browning Arms Company, Morgan, Utah, with manufacture by Miroku in Japan.
Mounting interfaces are ready to use, including a one-piece Picatinny scope rail on the receiver and a short MTNGEAR Picatinny accessory rail installed on the forend. These provide straightforward options for optics and compatible accessories.