Remington Model 1100 Magnum 12 Gauge Semi-Auto, 21 inch Vent-Rib Full Choke, 3 inch Chamber, Factory Engraved, Bushnell Sportview Scope
This Remington Model 1100 Magnum 12 gauge pairs the proven gas-operated action with a 21 inch vent-rib barrel, a 3 inch chamber, and a fixed Full choke. Factory scroll engraving decorates both sides of the receiver, which is marked "MAGNUM," and the barrel carries the "12 GA. MAGNUM FOR 3 IN. SHELLS" rollmark. It comes equipped with a Bushnell Sportview 2.5x32mm scope on a Weaver SIDE-MT side mount, adding a clean, installed optics setup to a classic, checkered wood configuration.
Condition
Overall Condition: Good condition, showing some signs of prior use and handling.
Bore Condition: Excellent - Clean, mirror finish, no signs of wear.
Specific Condition Notes: There are minimal markings from previous handling and use. Please refer to the photos for close-up views of surfaces and details.
What's Included
- Optic: Bushnell Sportview 2.5x32mm 1" Duplex scope (installed)
- Scope Mount: Weaver SIDE-MT side mount (installed)
- Scope Rings: Weaver rings (installed)
The Model 1100 Magnum configuration is purpose-built for 3 inch 12 gauge shells. This example has a 21 inch vent-rib barrel with a fixed Full choke and a vent-rib sighting plane, giving it a straightforward and durable 3 inch chamber/Full choke setup favored for heavier loads.
The receiver carries factory scroll engraving on both sides and is rollmarked "MAGNUM." The serial suffix "M" denotes the 12 gauge Magnum receiver. The barrel shows the "12 GA. MAGNUM FOR 3 IN. SHELLS" marking alongside the Remington Ilion, N.Y. maker’s rollmark.
The overall finish is gloss blue/black on the receiver and barrel.
The stock and forend are gloss-finished wood with checkering and fleur-de-lis panels. A Remington-branded ventilated recoil pad with a white-line spacer is fitted, and the length of pull measures 14.0 inches. Additional details include a rear sling-swivel stud and a knurled magazine cap.
A Bushnell Sportview 2.5x32mm 1" scope is installed using a Weaver SIDE-MT side mount and Weaver rings. This side-mount configuration provides a sturdy, receiver-mounted optics solution without altering the vent rib.