Bersa M2XI 9mm 2011-Style Pistol, 5 in Match Bull Barrel, Brushed Stainless, Optics Cut, 18+1, Cyelee CAT0 Installed
This Bersa M2XI is a full-size, double-stack 9mm built on a 2011-style platform and made in Cartersville, Georgia. It pairs a brushed stainless upper with a polymer grip module, a 5 in match-grade bull barrel, and a factory optics cut compatible with the Holosun K footprint. An installed Cyelee CAT0 micro red dot rounds out a feature-rich, single-action configuration with 18+1 capacity.
Condition
Overall Condition: Very good condition, showing only light, superficial signs of prior handling or use.
Bore Condition: Excellent - Clean, mirror finish, no signs of wear.
Bore Rifling: Excellent Rifling - Sharp lands and grooves.
Specific Condition Notes: Minor surface scratches and small blemishes are present on the exterior.
What’s Included
- 2x 18rd mags
- Optic: Cyelee CAT0 micro red dot sight (installed)
- Optic Plate: Factory optics-cut cover plate
- Recoil System: Recoil spring and plunger
- Manual: Bersa M2XI Family Operation Manual (2025 models)
- Case: Factory soft pistol case
- MagNotes: Steel double-stack magazines (shown)
The M2XI uses a stainless steel upper with a polymer grip module and a flared, removable magazine well for fast reloads. It carries 18+1 rounds in steel double-stack magazines and features a full-length dustcover with a 5-slot Picatinny accessory rail.
The 5 in stainless, match-grade bull barrel is bushingless with a target crown and 1:10 RH twist. A two-piece full-length guide rod supports the single-action, recoil-operated system, and the Series-70 style lockwork omits a firing-pin block.
The brushed stainless slide includes forward lightening windows, rear cocking serrations, and top anti-glare grooves. Iron-sight configuration may vary by example.
A factory optics cut (Holosun K footprint) is topped with a Cyelee CAT0 micro red dot. The pistol also includes the factory cover plate.
Controls include an ambidextrous manual thumb safety and a grip safety. A flat, skeletonized trigger with an over-travel screw and a skeletonized hammer complete the setup.