Daniel Defense DDM4 M4A1 5.56 NATO, 14.5 in CHF Barrel Pinned/Welded to 16.5, RIS II FDE, Fixed-Mag Compliant
This Daniel Defense DDM4 M4A1 stands out with its genuine M4A1 RIS II FDE quad rail, cold hammer forged chrome-lined 14.5 in M4-profile barrel pinned and welded to a legal 16.5 in overall length, and factory ambidextrous GRIP-N-RIP charging handle. It is configured in a fixed-mag compliant setup that replaces the bolt catch and requires removing the upper from the lower to release the magazine. The upper is M4A1-marked with correct forging and rail identifiers, offering the features and markings buyers look for in this model.
Condition
Overall Condition: Very good condition, showing only light, superficial signs of prior handling or use.
Bore Overall Condition: Excellent - Clean, mirror finish, no signs of wear.
Bore Rifling: Excellent Rifling - Sharp lands and grooves.
Specific Condition Notes: This rifle shows a few small scratches and blemishes from light handling. The bolt catch has been replaced with a compliant fixed-magazine device that requires the upper to be removed from the lower to release the magazine.
What’s Included
- Daniel Defense factory hard case
- 1x 10-round magazine (fixed-mag configuration)
- 2 spare Daniel Defense buttstock buttpads
The barrel is a 14.5 in Daniel Defense cold hammer forged, chrome-lined M4-profile unit with a pinned and welded flash hider, yielding a legal overall barrel length of about 16.5 in. It uses a carbine-length gas system and direct impingement action, delivering the configuration associated with the M4A1 pattern.
The handguard is the Daniel Defense M4A1 RIS II free-float quad rail in FDE, 12.25 in long and machined from 6061-T6 aluminum. It is marked with P/N 01-004-08001 and NSN 1005-01-547-2624 and features T-marked rail sections. The upper receiver is marked "M4A1" with the caliber oval "5.56" and carries the "A" forging mark, while the bolt is stamped with the Daniel Defense "DD" monogram.
Controls and furniture include the Daniel Defense GRIP-N-RIP ambidextrous charging handle, a Daniel Defense collapsible buttstock with rubberized panels and a molded buttpad, and a Daniel Defense rubber-overmolded pistol grip. Length of pull is adjustable to approximately 10.5–14 in. The aluminum receivers wear a black hard-coat anodized finish, pairing with the FDE rail for a two-tone look.
This rifle is configured for compliance with a fixed-magazine device occupying the bolt-catch position. To release the magazine, the upper must be removed from the lower. Capacity is 10+1 with the included short, state-compliant pattern magazine.