Smith & Wesson Performance Center Model 629-6 .44 Magnum Revolver, 2.625 in Barrel, Stainless, Unfluted 6-Shot, DA/SA
This Smith & Wesson Model 629-6 Performance Center revolver delivers big-bore .44 Rem Magnum performance in a compact, 2.625-inch package with distinctive Performance Center features. It pairs a matte stainless N-frame with an unfluted six-shot cylinder, fixed sights with an orange-insert ramped front, and checkered hardwood finger-groove grips. Built in the United States, it includes sculpted barrel flats, a recessed crown, and a full underlug for a refined, purpose-built presentation.
Condition
Overall Condition: Very good condition, showing only light, superficial signs of prior handling or use.
Bore Overall Condition: Good - Clean, well-maintained, minor wear marks.
Bore Rifling: Good Rifling - Intact, well-defined lands and grooves.
Specific Condition Notes: There are a few small scuffs on the exterior surfaces and mild signs of prior handling and wear.
What’s Included
- Smith & Wesson factory hard case
- Smith & Wesson Safety & Instruction Manual — Revolvers (Modern Style)
The Performance Center configuration stands out with a 2.625-inch stainless barrel featuring sculpted flats, a full underlug, and a recessed crown. The unfluted six-shot cylinder complements the compact barrel length while retaining the robust N-frame foundation.
Stainless steel construction is used for the frame, barrel, and cylinder, all finished in matte stainless. The revolver is built on an N-frame round-butt configuration and wears checkered hardwood finger-groove grips for a secure, natural hold.
Sights are fixed, with a ramped front sight that includes an orange insert and a fixed rear notch integral to the topstrap. The topstrap is serrated, and the ejector rod is shrouded with a knurled tip.
This double-action/single-action revolver features an exposed hammer and an internal key lock. It is chambered in .44 Rem Magnum and also chambers .44 Special, with a six-round capacity.
Markings include "Made in U.S.A." and "Smith & Wesson • Springfield, MASS." along with an assembly/inspection stamp "331" on the yoke cut.