Browning X-Bolt Stainless Hunter .270 WSM Bolt-Action Rifle, 23 in Stainless Barrel, Walnut Stock
This Browning X-Bolt Stainless Hunter in .270 WSM combines a 23-inch stainless sporter barrel with a satin-finished walnut stock and matte stainless metalwork. Built by Miroku in Japan and marked accordingly, it features the three-lug X-Bolt action, the user-adjustable Feather Trigger, and Browning's X-Lock scope mounting interface. It includes installed 30mm crossbolt rings on X-Lock bases and a factory Short Magnum rotary magazine.
Condition
Overall Condition: Very good condition, showing only light, superficial signs of prior handling or use.
Bore Condition: Excellent - Clean, mirror finish, no signs of wear.
Bore Rifling: Excellent Rifling - Sharp lands and grooves.
Specific Condition Notes: Light handling marks are present from previous use. Please review the photos for a close look at the cosmetic details.
What’s Included
- Installed 30mm crossbolt rings on X-Lock bases
- Factory Browning polymer rotary magazine marked "SHORT MAGNUM"
Chambered in .270 WSM, this rifle uses a 23-inch stainless barrel specific to the WSM configuration. The barrel is a non-fluted sporter contour with a recessed crown for protection, and the metalwork wears a matte stainless finish. The rifle is set up without iron sights.
The X-Bolt action uses a three-lug bolt with approximately a 60-degree lift for scope clearance and fast cycling. The tang-mounted safety pairs with a separate bolt unlock button so the action can be opened with the safety engaged.
Browning's Feather Trigger is a single-stage, user-adjustable design that promotes a clean break. The detachable rotary magazine system is tailored for Short Magnum cartridges, providing a 3-round capacity (3+1 with a round chambered).
The walnut stock features a satin finish with bordered checkering and a straight comb. Browning's Inflex recoil pad and sling swivel studs add practical utility, and the length of pull measures 13.5 inches.
For optics mounting, the receiver uses Browning's X-Lock four-screw interface and is drilled and tapped. This example comes with installed 30mm crossbolt rings on X-Lock bases.