Kimber Stainless Pro Raptor II .45 ACP Custom Shop 1911, Satin Stainless, 4-inch Match Barrel, Two 8-Round Magazines, Case
This Kimber Stainless Pro Raptor II comes from Kimber's Custom Shop and features the model's distinctive Raptor fish-scale texturing across the slide, top rib, front strap, and mainspring housing. Built on a satin stainless, all-stainless-steel 1911 platform with a Pro-length 4-inch match-grade barrel, it pairs Custom Shop fit and finish with practical carry dimensions. It includes two 8-round magazines, a Kimber hard case, and an installed 1911 magazine well funnel.
Condition
Overall Condition: Very good condition, showing only light, superficial signs of prior handling or use.
Bore Condition: Excellent - Clean, mirror finish, no signs of wear.
Bore Rifling: Excellent Rifling - Sharp lands and grooves.
Specific Condition Notes: There are light handling marks from previous use. Please refer to the photos for close-ups of surfaces and markings.
What’s Included
- Kimber hard case
- Two 8-round single-stack steel magazines with base pads
- Installed 1911 magazine well funnel
The Stainless Pro Raptor II is a Custom Shop model marked "CUSTOM SHOP" on the left side of the slide and "STAINLESS PRO RAPTOR II" on the right. Its signature Raptor fish-scale texturing appears on the slide (front and rear cocking serrations), along the top rib of the slide, and on the front strap and mainspring housing. Wood grip panels with Raptor texture and the Kimber logo complete the look.
The pistol is built on a stainless-steel frame and slide with a satin stainless finish. It wears fixed, low-profile three-dot sights and a skeletonized commander-style hammer. The trigger is match grade aluminum and includes an overtravel screw.
Chambered in .45 ACP, this 1911 uses a single-action, semi-automatic operating system. It features a Pro-length 4-inch match-grade barrel and an 8+1 capacity using the included magazines. Safety features include a manual thumb safety, a beavertail grip safety, and a Swartz-type firing-pin block.
Ergonomics and handling are supported by a government-length grip frame, a beveled magazine well opening, and the installed 1911 magazine well funnel. Factory dimensions are approximately 7.7 inches in overall length and 1.28 inches in width, with a listed weight of about 35 ounces. Made in the USA.