Taurus Circuit Judge .45 Colt/.410 DA/SA Revolving Carbine, 18.5 in Rifled Barrel, Fiber-Optic Sights, Blued, 5-Shot
The Taurus Circuit Judge is a distinctive DA/SA revolving carbine chambered for both .45 Colt and .410 bore. This example features an 18.5-inch rifled steel barrel with a threaded, removable choke, fiber-optic iron sights, and a short, screw-attached Picatinny/Weaver rail section over the receiver. Its hardwood stock with Monte Carlo comb and ventilated rubber recoil pad adds comfort and control, while gas-deflector blast shields at the cylinder are purpose-built for this platform. It comes with the factory Rossi/BrazTech box and manual.
Condition
Overall Condition: Very good condition, showing only light, superficial signs of prior handling or use.
Bore Overall Condition: Excellent - Clean, mirror finish, no signs of wear.
Bore Rifling: Excellent Rifling - Sharp lands and grooves.
Specific Condition Details: There are some markings from previous handling and use. The bore is bright and clean. See photos for details.
What's Included
- Rossi Firearms Owner's Manual for Shotguns/Rifles Circuit Judge
- Factory Rossi/BrazTech carton marked SCJ4510 with matching serial
This revolving carbine uses a 5-round, swing-out cylinder and operates in double-action or single-action. Gas-deflector blast shields at the cylinder are engineered for safe and controlled operation with this platform. The fiber-optic sighting system pairs a red front blade with a fully adjustable green rear for clear, high-contrast alignment.
The 18.5-inch rifled steel barrel is threaded and equipped with a removable choke, supporting the platform’s dual-caliber design in .45 Colt and .410 bore. The interchangeable choke system provides the correct interface at the muzzle for .410 usage.
A short, screw-attached Picatinny/Weaver rail section is mounted over the receiver/barrel block for mounting as needed. The receiver is steel with a blued finish, complemented by a bright-finished cylinder for a clean, purposeful look.
The stained hardwood stock and fore-end include a Monte Carlo comb, a ventilated rubber recoil pad with white line spacer, and sling swivel studs. Length of pull measures 14.5 inches. Markings include BrazTech, L.C., Miami, FL import information, "MADE IN BRAZIL BY TAURUS," and the Taurus bull logo. Manufactured by Taurus in Brazil and marketed by Rossi/BrazTech; model designation SCJ4510.