Gunwerks Magnus GLR 6.5 Creedmoor Bolt-Action Rifle, 20 in Carbon-Fiber-Wrapped Barrel, Threaded with Muzzle Brake, Carbon-Fiber Stock
This Gunwerks Magnus in 6.5 Creedmoor is built on the GLR action with a right-hand, spiral-fluted bolt and oversize faceted bolt knob. It features a 20 inch carbon-fiber-wrapped barrel with a threaded muzzle and removable brake, and a carbon-fiber composite stock with QD sling interfaces and a recessed Picatinny forend rail. The rifle uses an internal box magazine with a hinged floorplate (3+1 capacity) and is marked Gunwerks, LLC. Cody Wyoming. Overall length is a factory-specified 40.5 inches for the 20 inch barrel, and the bore condition is excellent.
Condition
Overall Condition: Very good condition, showing only light, superficial signs of prior handling or use.
Bore Overall Condition: Excellent - Clean, mirror finish, no signs of wear.
Bore Rifling: Excellent Rifling - Sharp lands and grooves.
Specific Condition Notes: There are light surface scratches and small blemishes on the exterior. The stock shows superficial surface scratching.
What's Included
- Gunwerks-branded hard rifle case
- Muzzle brake (installed)
- Recessed Picatinny forend rail section (installed)
- Safety chamber flag
The Magnus is built on Gunwerks' GLR action and configured for right-hand operation. The spiral-fluted bolt body and oversize, faceted bolt knob aid manipulation, and the receiver uses an enlarged right-side sporter/long-port ejection port. Feeding is from an internal box magazine with a hinged floorplate for a 3+1 capacity.
The 20 inch barrel is carbon-fiber-wrapped to reduce weight while maintaining rigidity. The muzzle is threaded and fitted with a removable brake. The barrel is chambered in 6.5 Creedmoor, with the barrel stamp marked "6.5 CDMR." The action/receiver ring is marked "GLR."
The carbon-fiber composite stock shows a gray/black carbon weave with splatter accents and includes a textured recoil pad. Mounting options on the forend include a short recessed Picatinny accessory rail and an additional recessed three-fastener mounting interface. Sling attachment is supported by a left-side rear QD flush cup and a separate front QD cup.
The receiver top is drilled and tapped for scope bases, and the rifle is configured without iron sights. Factory markings read "Gunwerks, LLC. Cody Wyoming," indicating its U.S. manufacture. Length of pull measures 13.25 inches, and overall length is 40.5 inches with the 20 inch barrel installed.