Smith & Wesson Model 25-5 .45 Colt DA/SA N-Frame Revolver, 6 in Pinned Barrel, Adjustable Sights (1980–1981)
This Smith & Wesson Model 25-5 is a classic N-frame target revolver chambered in .45 Colt, produced in 1980–1981 with pre-1982 pinned-barrel construction. It features a 6-inch barrel with a full-length serrated rib, a Baughman-style ramp front sight with an orange insert, and an adjustable rear sight. The revolver presents a silver-toned finish over carbon steel with factory target stocks and S&W medallions, and its bore is bright and clean with sharp rifling.
Condition
Overall Condition: Good condition, showing some signs of prior use and handling.
Bore Overall Condition: Excellent - Clean, mirror finish, no signs of wear.
Bore Rifling: Excellent Rifling - Sharp lands and grooves.
Specific Condition Notes: There are visible markings from previous handling and signs of moderate use. The bore is bright and clean. Refer to the photos for a detailed look at the surfaces and markings.
What's Included
- Allen zippered pistol soft case with Realtree camo pattern
The Model 25-5 pairs the robust S&W N-frame with the .45 Colt cartridge, delivering a six-shot, fluted-cylinder revolver in a traditional DA/SA configuration. Its square-butt grip frame is fitted with large factory target stocks featuring S&W medallions for a secure, full-hand hold.
The 6-inch pinned barrel wears a full-length, serrated top rib and a shrouded ejector rod with a knurled tip. Sight alignment is fast and clear thanks to the pinned Baughman-style ramp front sight with an orange insert and an adjustable square-notch rear sight.
Construction is all carbon steel with a consistent silver-toned finish across the frame, cylinder, and barrel. Controls include a wide, checkered hammer spur, a smooth-faced trigger, and a checkered cylinder latch, all aligned with S&W’s target-revolver setup of the period.
Manufactured in the United States during 1980–1981, this pre-1982, pinned-barrel example reflects features valued by enthusiasts of the Model 25 line. Assembly numbers are present inside the crane (e.g., 34898 and E8), consistent with factory internal fitment tracking.