Smith & Wesson Model 10-6 .38 Special Heavy Barrel 4-Inch DA/SA Revolver, Blued (1972-1973)
This Smith & Wesson Model 10-6 is a classic K-frame service revolver with the desirable 4-inch heavy, non-tapered barrel. Built in the early 1970s, it features a polished blued carbon steel finish, fixed sights, and the robust DA/SA action that defines the Model 10 line. This example includes Pachmayr Gripper rubber finger-groove grips and yellow paint applied to the front sight face for a bold sight picture.
Condition
Overall Condition: Good condition, showing some signs of prior use and handling.
Bore Overall Condition: Good - Clean, well-maintained, minor wear marks.
Bore Rifling: Good Rifling - Intact, well-defined lands and grooves.
Scratches and blemishes are present, with areas of finish wear. Small, infrequent deposits of pitting are visible. The grips are oversized for this model.
What’s Included
- Smith & Wesson Model 10-6 .38 Special revolver with 4-inch heavy barrel
- Pachmayr Gripper rubber finger-groove grips (installed)
- Yellow paint applied to the front sight face
The Model 10-6 is marked "MOD. 10-6" on the yoke and retains the hallmark K-frame profile with a 4-inch heavy, non-tapered barrel and an unshrouded ejector rod. It is chambered in .38 Special with a 6-round cylinder and a double-action/single-action operating system. Assembly numbers are present on the yoke cut.
The revolver wears a polished blued finish on its carbon steel frame and cylinder. Controls include a smooth, service-width trigger and a checkered hammer spur.
Sight regulation is straightforward and durable, using a fixed square-notch rear integral to the topstrap and a ramped front blade. The front sight face has been painted yellow to enhance visibility against a variety of backgrounds.
Aftermarket Pachmayr Gripper rubber finger-groove grips are installed. These grips are oversized for this model and provide a secure, hand-filling hold.
