Winchester Model 1200 Defender 12 Gauge Pump-Action, 18.5" Fixed Cylinder Bore, Rifle Sights, 4+1, Late 1970s New Haven Production
This late-1970s Winchester Model 1200 Defender pairs a factory 18.5" smoothbore, fixed cylinder bore barrel with rifle sights to a standard-capacity 4+1 receiver. Built in New Haven, Connecticut, it features the Model 1200's rotating multi-lug bolt, an alloy receiver with an anti-glare rib, and a chamber marked for both 2 3/4" and 3" shells. It also includes an additional 28" barrel roll-marked "MODEL 200 12 GA 3 CHAM. FULL," adding versatility to the package.
Condition
Overall Condition: Fair condition, showing extensive signs of prior use and handling.
Bore Overall Condition: Good - Clean, well-maintained, minor wear marks.
Specific Condition Notes: There is surface pitting across the barrel and the magazine tube. A small chip is present on the bottom of the stock.
What’s Included
- Additional 28" barrel roll-marked "MODEL 200 12 GA 3 CHAM. FULL"
- Elastic buttstock shell carrier (installed)
The heart of this shotgun is the Winchester Model 1200 pump-action system with a rotating multi-lug bolt that locks into a barrel extension. It ejects to the right and uses a cross-bolt safety with a red indicator for clear status confirmation. The alloy receiver carries a longitudinal anti-glare rib along the top.
The factory Defender 18.5" barrel is Winchester Proof Steel and marked for 2 3/4" and 3" shells. It is a smoothbore with a fixed cylinder choke—Fixed Cylinder Bore—and mounts rifle sights: a ramped front blade with a white insert and an adjustable rear leaf on the barrel.
This Defender barrel is fitted to a standard-capacity Model 1200 receiver configuration. The magazine tube is the standard length with a knurled cap and a single barrel ring, yielding a 4+1 capacity. The finish is blued/black on the receiver and barrel.
Furniture is classic Winchester: a grooved wood "corncob" forend and a wood stock with a walnut finish and a factory Winchester hard-rubber buttplate. Length of pull measures 14.0 inches.
Production traces to New Haven, Connecticut in the late 1970s (1977–1979). An additional 28" barrel roll-marked "MODEL 200 12 GA 3 CHAM. FULL," and an installed elastic buttstock shell carrier are included.
